The 1980 Weapon Mount is capable of carrying out various
tests of small arms and ammunition and weapons when mounted on a suitable
base. The objects of these tests is to ensure consistent proof results are
obtained regardless of where and who carries out the proof.
The 1980 Weapon Mount is complete within itself and requires only a suitable rigid mounting and any such adaptors or fixtures as needed to secure the weapon system under proof. The aparatus serves to hold the weapon in simulated service condition while the ammunition / weapon proof is carried out.
The barrel section of the weapon is held in the front support by a clamp, while the butt is retained in moulded pad attached to the rear support. When the weapon is fired the recoil is absorbed by the pneumatic system, and returned to it's original position by the internal spring, air pressure and hydraulic pressure.
Description of the proof equipment
The apparatus consistes of the following assemblies :- Front Support, Rear Support, Guide Assembly, Clamp Assembly, Slide Assembly, Air Supply System, Frame, Vee Rest and Base plate.
This is mounted on the base plate and carries the elevating ring, locking ring and a cup carrier. A pillar is keyed to the central shaft and carries the guides for the vee rest. The vee rest has a clamp which secures the barrel of the weapon used for the proof.
This is also mounted to the base plate and carries the clamp assembly, housing shock absorber and the hydraulic / air systems. There is an option for the body of this item to be manufactured from aluminium or steel, but this is dependent on the operators preference.
The base plate is made of solid
1" steel stock and has a series of slots and tee slots machined into
the top face to enable accurate alignment and positioning of both the front
and rear supports.
Picture below show's the 1980 Weapon Mount PF 7057 on a Witworth Rest
For further details on this equipment please contact on Evridge Engineering Co Ltd
Tel: +44 (0) 1322 868961
Fax: +44 (0) 1322 868962